El manego de ła presion sołievo vałutasion de esar proteta dała posision de sołievo de presion prima che ła potensa ła vien inpisà, e po' ła presion de ła presion ła vien mesa su ła presion de ła presion el manego de ła presion dopo l'uso normałe del motor; after the above steps, the injection needs to be performed, then before the compression The model needs to be heated to the specified temperature to be able to press into the metal solution. The operator must wear protective glasses when working, and the protective baffle is not required for the parting surface contact and the gate of the mold, and the operator must not stand. On the opposite side of the parting surface contact, in order to prevent splashing of metal liquido.
There is an open flame at the place where the working equipment is working. If the temperature of the tank exceeds the operating temperature of the equipment during operation, it needs to be cooled immediately with water. The tool is used to remove the casting from the die-casting mold, and even the clear mold and vent hole Internally adhered metal debris; co se conpleta tuto el laoro, ła pompa de petrołio el ga da esar fermà, e ła valvola ła xe serà par spegner el podere.
